Fuji NP1PU-256EZM Module

Fuji NP1PU-256EZM 100% New And Original Module In Box

Description

Like other spraygun manufacturers, we use ‘stock’ stainless steel rodfor the needle. This rod can differ in diameter slightly with each run. Thismeans that when you change say, a #3 for a #4 needle. One could beslightly oversized diameter and one slightly undersized. Thisneccessitates adjusting the needle seal.The needle seal bushing (packing) must be tight enough to prevent anyleakage of paint material into the gun. It should however, allow theneedle to glide smoothly through it. If this bushing is too loose often a‘pulsating’ of the spray pattern will be seen. 

Insert the needle sealadjusting tool (with teeth pointing downwards) over the needle. This isthe tubular-shaped tool that comes with the complete Fuji system.Locate the slots in the needle seal nut and tighten the needle seal whilecontinually pulling the trigger. (If the slots are clogged with paint, use asharp screwdriver to clean out the slots). Once the needle is grabbed bythe seal, back off the screw a very slight amount. The needle seal isadjusted perfectly just short of the point where the needle sticks. Anotherguide is to grasp the end of the needle and shake it firmly but gently fromside to side - there should be no play - but the needle should still slidesmoothly without sticking when the trigger is pulled. The needle sealshould never need replacing.

Fuji Products

You May Like

Advantage Products

1.Allen-Bradley 1756/1769/1771/1785 Series

2.ABB 800xA/Bailey INFI90/DSQC Series

3.Bently Nevada 3500/3300 Monitoring System

4.Schneider Series Quantum 140 series

5.General Electric IC693/IC697/IC698/IS200/DS200 Series

6.SIEMENS MOORE/S5 Series

7.Westinghouse: OVATION/WDPF/MAX1000 system spare parts

8.Invensys Triconex: Redundant fault-tolerant control system, Most modern fault-tolerant controller based on Triple Modular Redundancy (TMR) architecture

9.Honeywell TDC2000/TDC3000/Experion HS Series

10.YOKOGAWA CS3000 System